Exergen Global: Non-contact thermal sensors are remarkably diverse devices that can help ensure higher process speeds, more precise accuracies, tighter tolerances, and higher yields for a wide spectrum of manufacturing processes, including...
greenTEG AG: This brief case study presents the challenges of performing a U-value measurement on a roof and the precautions and steps to overcome them. The challenges of measuring a very low Uvalue and the corresponding measurement quality...
greenTEG AG: Researchers used greenTEG’s gSKIN heat flux sensors to study the effects of electrode composition on heat generation in Electrical Double Layer Capacitors (EDLCs). The heat flux sensors were integrated within an isothermal...
greenTEG AG: Research civil engineers investigated how permafrost can be protected from global warming effects using crushed-rock layers. With greenTEG’s gSKIN® XP heat flux sensors, temperature sensors and albedometers, the thermal...
InfraTec GmbH: Pyroelectric detectors are ideally suited for gas analysis. Until now, this has been complicated if many gases should be measured. There were often simply too few measuring channels for this purpose. The new LRM-278 from InfraTec...
WIKA: An individual red-green marking on pressure gauges and dial thermometers is now also possible using an adhesive label. WIKA offers a corresponding set of arcs for nominal sizes 63, 100 and 160. The red and green arcs can be mounted in...
Heitronics: Infrared radiation thermometers measure the gas temperature in combustion processes quickly and reliably. The sighting depth of the device depends on the process conditions and the selected wavelength. Heitronics has developed an...
Exergen Global announced the industry’s only non-contact thermal dynamic management solution to combine a proprietary-design cooling mechanism with a unique emissivity control device to provide accurate, repeatable thermal measurement...
E+E Elektronik: The EE850 duct mount sensor from E+E Elektronik combines the CO2, relative humidity (RH) and temperature (T) measurement in a single device. The sensor can be easily integrated into a bus system via the RS485 interface (Modbus RTU...
greenTEG AG: Thermophotovoltaic (TPV) devices produce the direct conversion of radiant heat into electricity using infrared sensitive photovoltaic (PV) cells. Despite its relatively mature stage of development a standardized method for the...
Balluff is expanding their range of sensors for media-contacting temperature detection, in hydraulic power units for example. New are a temperature sensor with display, a temperature transmitter as well as a PT1000 sensor .The version without...
Optris GmbH: In time for the electronica 2018 trade fair, Optris was introducing an additional infrared camera in their new Compact Line onto the market. The optris Xi 400 camera has been equipped with a microscope optics as well as a tripod...
Optris GmbH: In 2014 and 2016, Optris brought two special infrared cameras for the glass industry – the PI 450 G7 and the PI 640 G7 – to the market. In order to meet the industry-specific requirements, an innovative laminar air purge...
Exergen Global: Challenge: A large electric air heating solutions company needed a very fast thermal management solution to prevent overheating of the air heater element used in its flanged inline heaters. The heaters are employed in industrial...
E+E Elektronik: The high-end EE310 and EE360 industrial transmitters from E+E Elektronik are now available with stainless steel or with polycarbonate enclosure. The EE310 humidity and temperature transmitter is dedicated for demanding industrial...
greenTEG AG: The European Union’s Horizon 2020 Program is the largest research and innovation funding program ever launched to support scientific progress. Under this program, the EU granted greenTEG phase 1 funding of 50’000€ to...
greenTEG AG: Congratulations to Simon Caron, Marc Röger and Johannes Pernpeintner from the German Aerospace Center’s Institute of Solar Research for their recent publication “Heat Flux and Temperature Measurements on Glass...
greenTEG AG: In a study performed by students at East Bavarian Technical University, the measurement quality of U-values measured with a Temperature Based Method (TBM) versus a Heat Flux Based Method (HFBM) were compared. It was found that the...
WIKA has further developed its standard bimetal thermometers for global application in the process industry. The model TG53 conforms to the ASME B40.200 standard and is manufactured for the inch unit of measure. The model TG54 has been qualified...
Exergen Global announced that its Micro IRt/c-HB infrared non-contact sensors are being used to measure blood product temperatures in the ThermaCor® 1200 Rapid Thermal Infuser designed and developed by Smisson-Cartledge Biomedical, LLC and...
greenTEG AG: Start your temperature and heat flux measurements straight out of the box with the gSKIN® XO-Temp sensor & MultiLog datalogger package. Quick & Easy Setup. No hassle with calibration, soldering wires or incompatible data...
Sensirion AG, the expert in environmental sensing, now offers a new humidity and temperature module, the SCC30-DB. Some applications require a humidity and temperature sensor to be located in a specific part of the device – often at a...
Baumer: With the new generation of universal temperature transmitters, FlexTop 2212 and 2222, Baumer is expanding its proven range of products. With integrated micro-USB port, automated cable compensation and a fast sampling time of less than 50...
PCE Instruments has used the experience of the recent years to develop a mobile, small and powerful data logger. The development and production were guided exclusively by the suggestions, experiences and wishes of the customers. For all the...
Exergen Global: Singulex is a California-based company providing a unique technology that can detect single molecules in bodily fluids, such as blood or urine. This capability holds real promise for medical diagnostics, particularly when being...
greenTEG AG: We will exhibit our solution for continuous, non-invasive core body temperature measurements for wearable and med-tech applications at the Websummit in Lisbon. Contact us for a meeting during the fair. The core body temperature (CBT)...
E+E Elektronik: The EE23 industrial transmitters from E+E Elektronik measure relative humidity and temperature and also calculate the dew point and frost point temperature. The new model EE23-T5 is suitable for a temperature range of -40 °C to...
Exergen Global introduced the D501LN, a handheld certified infrared scanner that provides all the features found in Exergen’s DX501, with an extended nosepiece to enhance safety and ease-of-use. The length of the nosepiece in the D501LN...
PCE Instruments: The brandnew datalogger PCE-VDL 16I of German origin measures temperature, air humidity, air pressure, light and acceleration in three axes. The data logging instrument is ideal for monitoring machine vibration and at the same...
greenTEG AG: Currently, there is a strong research effort of developing ‘smart’ building materials that respond to temperature changes in a way that improves building energy efficiency. One such method involves introducing Phase Change...
